Die Casting by LEMAC
24 Volt DC motor ideal for smooth speed control.
Long life brushes life dependent on duty cycle and application.
Permanently lubricated maintenance-free gearbox.
Ball bearings throughout motor and gearbox for high axial and radial load capacity.
Enclosure rated Ip44.
25:1 Ratio Gearbox.
High Temp. Delrin wormwheel.
LEMAC provide a total Non-Ferrous Pressure Die-casting service, from constructive input during component design, through tooling design and manufacture to volume component production, die maintenance and modification.
Our Die casting service is quality accredited to BS EN ISO 9002. If you would like more information or advice on your own specific requirements please contact us. You can get in touch via our contact form or, if you prefer, you can contact us at the address given at the bottom of this page.
In addition to the above activities we have designed and we manufacture a range of Die-cast Adjustable feet for use on catering equipment and on tubular fabrications.
LEMAC, Hospital Road, Haddington, East Lothian, Scotland
Phone: 01620 828700
Fax: 01620 828730